MR2 SpyderChat banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 19 Results
  1. MR2 Spyder Main Forum
    I was digging around the engine bay and found this connector, not sure where it goes...
  2. MR2 Spyder Main Forum
    Hi all, just a little update on the conversion from SMT to MT. It's one of the trickiest things that I have done ever.... The car (which was bought at the end of February) is still sitting at my workplace as I'm working on it on weekends, I've nearly gotten the mechanical side of things done bar...
  3. Care, Maintenance, and Troubleshooting
    I recently purchased a 2001 model as a project car and it has loads of problems. A lot of these problems are electrical, such as the horn not working, the blinker not working, the radio not working, etc. Does anybody have a wiring diagram I could see, or any advice?
  4. Appearance Modifications
    Hey all, just wanted to share my custom foglight install on a 2002. Got this basic glass foglight kit off Amazon: https://a.co/d/e6lVteM Wanted to make it as OE as I could, so I wired into the spare relay and fuse slots in the lighting and interior boxes respectively: And here's how the...
  5. Appearance Modifications
    Hi, New member and my first post here. I did the headlight lens delete on my 00 mr2, followed a thread on her about it. Only thing i cant quite figure out is the wiring. Ive managed to get the headlights on, turn signals and halo to work just by tapping into the regular stock wires but im...
  6. Engine Management
    Greetings all, I am new to this forum and I have seen several posts about this but with no much details or specs. So it happens that I am converting a 2ZZ JDM engine to Speeduino UA4C and I am looking to do a plug and play harness using an old ECU to take the header. While looking at pinouts I...
  7. Care, Maintenance, and Troubleshooting
    Hey everyone, I'm new here but have been rebuilding an absolute wreck of a Spyder I bought from my cousin a few months ago (he successfully 2zz swapped it, drove it around for a few months and it overheated. needed head work which was done and then the car just sat). I have gotten to the point...
  8. Audio and Electronics
    i wanted my dash simply to be blue instead of orange, of course this wasn't as simple as i had hoped for. So i ordered this 'indiglo gauge' (Toyota MR2 - 3gen. design 1) so the plugs that can be seen go into a converter an the converter needs to be wired to the car. The company states 'If...
  9. MR2 Spyder Main Forum
    Hello All, I have been a member since first MR2 purchase in 2015, but life started handing me a few bumps - I know no one has time for the details, the short list includes slipped disc in neck, and working away from home for 2 of last 3 years, a couple spans of un-employment, etc. Being...
  10. Audio and Electronics
    Getting ready to add a second (loud) highway horn to augment (wimpy) OEM horn. Does anyone know positively if the OEM relay is switch ground (-) or power (+) actuated? Once I know that, it will make my wiring job go much faster and easier. Thanks In Advance! Paul
  11. Performance Modifications
    Hi. Where i can find a 2ZZ plug n' play wiring arness for an Haltech (Elite 750 for example) EMS? Thanks.
  12. Performance Modifications
    Hi. Is there any bad consequence or damage to the engine when driving my 2ZZ Spyder without having modified the wiring? Thanks.
  13. Audio and Electronics
    Evening Folks: I would like to add some additional electrical devices to my Spyder: extra loud main horn; heated car seats; possible driving/fog lights. So I was thinking that it might be very helpful to run a single hard wire (and, obviously, fused) from the positive terminal of the car...
  14. Care, Maintenance, and Troubleshooting
    I know somebody already posted about a similar problem with the 02 mr3, but I heard somewhere that a possible fix for the reverse gear problem (it rarely goes into reverse successfully without dying) would be to disconnect the wiring to the steering column transmission shortcut. Is that...
  15. Care, Maintenance, and Troubleshooting
    ...so this problem has been driving me nuts. My turn signals will randomly start doing the fast blinking thing that says 'Hey, one of your bulbs is burned out, dummy, go check it!' I check my bulb (rear right side, usually). Not burned out. Put it back in, and the problem goes away...but then...
  16. Audio and Electronics
    Scion(Pioneer) Radio/CD T1806 player HU I have will ONLY play the CD if I turn the car off and on with the CD already in it. Radio works fine and it has no disk error statements. It won't play the CD if I switch it to radio then back to CD player,change disks, nor if I power off the radio and...
  17. Care, Maintenance, and Troubleshooting
    Can someone help me figure out what these connectors are? I’m really trying to learn my way around this engine; this is waay more different than a carbureted small block Chevy.:D I know for the 2ZZ swap I need to swap the polarity of the TPS, but I have no clue where this is. I also have to...
  18. Audio and Electronics
    There are several different techniques out there for wiring up post face-lift headlights to a '00-02 car, but I wanted to see if there was a better method. So I did a little studying of the wiring diagrams and came up with something I don't believe has been tried before. The biggest hurdle of...
  19. Performance Modifications
    Was going to do a 2zz swap, but it's moving time
1-19 of 19 Results
Top