MR2 SpyderChat banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I'm getting new intake valves installed and the machinist asked for the valve tip height. I can't find this value anywhere in the workshop manuals or through searching the internet so maybe someone on here knows?

He also asked for spring installed height (1.323in), and valve stem to guide clearance (0.0010-0.0012in) so correct me if i'm wrong on those values please.
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #2 ·
Nobody knows? Or is this something the machinist can figure out himself because there's no documentation in valve tip height that I can find for the 1ZZ.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top