MR2 SpyderChat banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Is there a good 2zz harness diy I can follow. I have both harness pin outs saved that are footing around but I have never seen a picture of the harness and move this or that wire. Any help would be appreciated
 

·
Registered
Joined
·
126 Posts
Are you building it to run the stock 2zz ECU? If so just add the "lift" stuff to the 1zz wiring loom, flip a few wires around at the throttle body, flip a few around at the ecu and it's good. There are tons of write ups on this.
 

·
Registered
Joined
·
91 Posts
This is the most up to date version. When I first started researching the swap these charts were very confusing. ABCD refers to each plug on the harness.
78510
 
1 - 3 of 3 Posts
Top