MR2 SpyderChat banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
3,303 Posts
Discussion Starter · #1 ·
I'm looking at the install instructions on the Hako, and its asking for both a signal (+) and ground (-) for a WBo2 input, but my AEM UEGO only has one 0-5v signal wire (white wire) or a serial output (blue wire). Anyone know how I would wire this in so it works properly?
 

·
Registered
Joined
·
7,797 Posts
I'm looking at the install instructions on the Hako, and its asking for both a signal (+) and ground (-) for a WBo2 input, but my AEM UEGO only has one 0-5v signal wire (white wire) or a serial output (blue wire). Anyone know how I would wire this in so it works properly?
Well, you have two choices -- wire the 0-5V to the signal wire and either leave the ground floating or ground it as close as possible to the UEGO ground point (most likely the latter will work best).
I'm pretty sure Kingspyder uses/used a UEGO with a Datalogit, should be similar.
 

·
Premium Member
Joined
·
3,303 Posts
Discussion Starter · #3 ·
That's easy enough, I'll wire it up this weekend and give it a try.
 

·
Premium Member
Joined
·
3,303 Posts
Discussion Starter · #4 ·
Its alive! Hahah.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top