MR2 SpyderChat banner
1 - 3 of 3 Posts

·
Registered
Joined
·
866 Posts
Discussion Starter · #1 ·
The mid pipe is leaning on the bottom panel.

How should I remedy this?
  • add a ton of spacer at the mid attachment
  • cut a hole where it touches
  • don't run a rear panel
  • put some kind of hi temp foam in that area to cushion the vibration

Hood Automotive tire Automotive lighting Motor vehicle Vehicle

Hood Automotive lighting Automotive tire Automotive exhaust Automotive design

Wheel Automotive tire Hood Tire Automotive lighting
 

·
Registered
Joined
·
866 Posts
Discussion Starter · #5 ·
Thank you for the advice. I went with removing the heat shield for that section. Was a pain to remove ended up using metal scissors to rip it out.
Light Wood Triangle Gas Automotive tire
Tire Wheel Automotive tire Hood Vehicle
 
1 - 3 of 3 Posts
Top