MR2 SpyderChat banner
1 - 4 of 4 Posts

·
Registered
Joined
·
501 Posts
Discussion Starter · #1 ·
is it possible to just remove the left hand tie rod without taking the entire front axle out like my BGB says too?
Also do any aftermarket company make replacement parts?
 

·
Registered
Joined
·
627 Posts
which axle are you talking about? the cv axles (rear) no axles i can think of in the front.
 

·
Registered
Joined
·
553 Posts
You could. Just use jack stands. Be safe. If you could, buy the inner tie rod tool or an open end would work. go easy on the boot. You might need to buy a new boot clamp. Might as well do both front inner and outer tie rod as preventive maint.
 
1 - 4 of 4 Posts
Top