MR2 SpyderChat banner

1 - 8 of 8 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
Hey guys, has anyone replaced one of these - can't seem to find much online? Assuming drill out any remaining pieces and install a new one but just wanted to make sure before I damaged something.
 

·
Registered
Joined
·
8,314 Posts
Its held on by a single 10mm bolt. Once the bolt is out the sensor should just pull out. Unplug wire and install new sensor.
 

·
Registered
Joined
·
26 Posts
Discussion Starter #3
10mm came out easy but the sensor was stuck. Ended up breaking it while trying to get it out.
 

·
Registered
Joined
·
3,046 Posts
I wouldn't use a drill , I'd dig it out with something sharp after pulling all the fine copper wire out by hand . These are pretty pricey new .
 

·
Registered
Joined
·
18 Posts
These are known to be a bitch. Just cleaned my rears. Gotta use a plyers and slowly wiggle it out to ensure no damage.
 

·
Registered
Joined
·
26 Posts
Discussion Starter #8
Thanks guys, got the new sensor from Rock Auto - will try the socket trick this week.
 
1 - 8 of 8 Posts
Top