MR2 SpyderChat banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello, i've had a little accident and now my rear wheel camber isnt right anymore.

I'm gonna take the camberbolts from H&R, and the company asked if i got the measurements from a particular part of the car.

Sadly i don't have my mr2 with me right now the following weeks, so my question was if anyone know the measurements of the following picture.

Thanks in advance!! :)
Gesture Font Gas Machine Auto part
 

·
Registered
Joined
·
3,501 Posts
If things aren't aligning you may want to double check the control/toe arms and hub for bends. My front left hub had a bend for years that was an easy replacement. The stock rear bolt is 15mm shoulder down to a 14mm shaft. 2 dot crash bolts (normally used in front) are 14mm shoulder down to 12mm shaft. All 19mm bolts/nuts.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
If things aren't aligning you may want to double check the control/toe arms and hub for bends. My front left hub had a bend for years that was an easy replacement. The stock rear bolt is 15mm shoulder down to a 14mm shaft. 2 dot crash bolts (normally used in front) are 14mm shoulder down to 12mm shaft. All 19mm bolts/nuts.
Thank you very much, will check that!!
 
1 - 4 of 4 Posts
Top