MR2 SpyderChat banner

Crankshaft Pulley replacement help needed

488 Views 21 Replies 7 Participants Last post by  MerryFrankster
2zz-ge engine, 2001 body.

I'm going to keep this short and save you all some second hand frustration. I picked up my car this weekend after 4 months of being repaired. New alternator, tensioner belt, PCV bleeder and some solenoid for VVTLI. After driving it for 1, one, hour at speeds between 55 to 75, I heard a loud clunk, looked in my rear view mirror to see if I ran over anything, and see the crankshaft pulley sailing away at ample speed. Took the next exit, looked at the engine, and yep its gone. Somehow the belt was intact too...Got a tow, and now car is at a friend's house.

My questions are:

1. Will this do any permanent damage to the engine?
2. Can I just get a new pulley and put it on there, route the belt and be fine?
3. Is there any way that I can see if the timing is incorrect without dropping the engine and removing the timing chain cover and looking at the teeth? Maybe through the OBD port?

I know a pulley tool can be rented from amazon and have all the manuals...just debating on calling an import/enthusiast shop in town and see what they charge because I live 40 minutes from where the car is located so I can't take other photos.

Open to suggestions/advice and thank you.

Crankset Bicycle tire Automotive tire Bicycle frame Automotive lighting
See less See more
1 - 2 of 22 Posts
Anyone know if this pulley is the same for 1zz & 2zz?
1 - 2 of 22 Posts
Top