MR2 SpyderChat banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,115 Posts
Discussion Starter #1
Hello I couldn't find a related thread so I posted.

There are two bulbs behind the A/C dials. Sometime the left bulb is on, sometimes the right, somethings both, nowadays neither are. Has anyone successfully resolved such a wiring issue?

Attached a picture for the case someone can't read but can write ;)


 

·
Registered
Joined
·
366 Posts
i have had this problem before... i just flick the ring where it shows the temp. dots a few times and the bulbs come on.
 

·
Registered
Joined
·
362 Posts
I can contest to this effect when installing leds... if it still stock then its time to replace the blubs.
If its led then it might the too long or the connection which is polarized.

Also the simplest solutiion is to check the 2 tabs that need to touch the circult board for power....it might be loose. You can also stick a piece of non flamible thingy in the back to press it against the board (which I did) to ensure connectivity.
 

·
Registered
Joined
·
1,115 Posts
Discussion Starter #5
Thanks people. I should have considered the fact that these stock bulbs, themselves, could simply be intermittent. I will get off my arse now and switch them out. If that doesn't do it I will finally use my education to trace the wiring issue.

//regret opening this thread.
 
1 - 5 of 5 Posts
Top