MR2 SpyderChat banner

1 - 6 of 6 Posts

·
Registered
2005 Toyota MR2 Spyder
Joined
·
48 Posts
Discussion Starter #1
This one has been "loved" but still has life left in it.

Asking $180obo shipped to lower 48


Good:
- new hose (yet to be installed)
- new clamps (some not pictured)

Bad:
- 2 holes in the heat shield that I fixed with Mastic tape (easily removable)
- several dings and scratches (battle scars :) )
- missing the two screws to attach the MAS (easily found at a hardware store)

Here are some pics. If you need to see more pics of anything just ask :)



 

·
Registered
Joined
·
7,223 Posts
I might be interested in just the shield, but the whole piece might be fine as ... some project later. Is the shield a completely enclosed thing? And how does it attach? Does it look like it could be mounted to fit around ... say a P.E. Intake filter?^_^
 

·
Registered
Joined
·
497 Posts
I've actually worn the same type of holes in both a PRM and Cobb CAI on other cars - though their filter enclosures are ABS or something similar.

And +1 for some aluminum mastic tape. I have a mastic "pasty," covering up one of the MR2's floorpan holes where PO dragged/scraped one of the rubber grommets out.
 

·
Registered
2005 Toyota MR2 Spyder
Joined
·
48 Posts
Discussion Starter #6
Sorry for the delay in getting back guys appears I didnt turn on auto notification and life has kept me busy.

This has officially been sold and shipped ! Thanks for all the interest!
 
1 - 6 of 6 Posts
Top