MR2 SpyderChat banner

1 - 4 of 4 Posts

·
Registered
Joined
·
977 Posts
Discussion Starter #1
hey guys im busy sorting out the preliminary stuff for my swap, and iv checked and searched but i cnt seem to find something on this, i see my knock sensor on my 2zz is the 2 wire on but its bolted onto a stud on the block, whereas the single wire seems screw straight onto the block, must i just unbolt the 2 wire sensor unscrew the stud and then screw the 1zz sensor in?
 

·
Registered
Joined
·
977 Posts
Discussion Starter #3
clever, so i assume that the stud is the same size as the knock sensor thread, got a bit worried when i looked under the intake
 
1 - 4 of 4 Posts
Top