MR2 SpyderChat banner

1 - 3 of 3 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter #1 (Edited)
For a race car build or non Spyder use or however you see fit to use it (cool display) $200

Unused MOMO MOD11 260mm (10.25”) black suede covered steering wheel andSPA quick disconnect. Wheel is $240 new and QD $200.

Suede is very difficult to photograph as the pictures make it look dirty. This has never been installed just hung out in the garage for a few years!

Wheel is drilled for QD either 3 or 5 holes.

QD will need the matching column spline from SPa which runs about $50 last time I looked.
79485

79486
 

·
Registered
Joined
·
118 Posts
Discussion Starter #3
Not sure if that a serious question or not :) If so there are ways around that, IMO that's the easy part, a strategically placed resistor will work. In order to fit this to a Spyder you'd need to weld the QD column spline adaptor to the OE column. For someone with a dedicated race car that's probably not too much of a challenge. If you don't want the QD i would imagine there are boss adaptors to make this work.

A quick visual aid to see how it would look:

79527
 
1 - 3 of 3 Posts
Top