MR2 SpyderChat banner
1 - 4 of 4 Posts

·
Registered
Joined
·
977 Posts
Discussion Starter · #1 ·
Hi guys I see my exhaust side torque mount is torn. What's your opinion, replace with new rubber bush or get a speed source poly set? I'm not sure about the poly cos I don't want too much engine vibration coming into the cabin.

If it makes any difference in Have a 2zz
 

·
Registered
Joined
·
501 Posts
I got the poly set in mine, the vibrationis not that bad bit you can still feel it but that might be because I have a 04 and it has extra bracing stock, only improvement I saw was no more jerky shifts that my SMT pulled on me, and avoid 2nd gear rolling starts
 

·
Registered
Joined
·
3,208 Posts
I put this set in mine, and there was a good bit of vibration, especially on launch, but only at first. If you get the revs up just a bit it would be avoidable, and now that there's a couple of thousand miles on them it only happens occasionally, like if I roll around a corner and down shift into 3rd when it should be 2nd. In other words, don't lug it and it doesn't vibrate.

http://www.monkeywrenchracing.com/product_info.php?products_id=1029
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top