MR2 SpyderChat banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
so i put the ppe intake on, what i noticed was it fits kinda tight back there but my concern is the bracket that the wiring harness is on is right up against it (attached to the firewall) no way can i put the wiring harness back on it.

Well point is i developed a nice rattle and i think thats it. Should i cut it off?
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
yeah i kinda figured out if i bend the battery hold down bar a smidge and stuff it further into the silicon connector it clears that but i think its rattling against the firewall now.
 

·
Registered
Joined
·
4,238 Posts
yeah i kinda figured out if i bend the battery hold down bar a smidge and stuff it further into the silicon connector it clears that but i think its rattling against the firewall now.
I had mine up against the battery bracket and it eventually rubbed a long hole through the filter cover...I just run without the cover now. But yea, it is a tight fit,
 
1 - 5 of 5 Posts
Top