MR2 SpyderChat banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,512 Posts
Discussion Starter #1
I already found this thread "how-to-rear-quarter-panel-removal", but I'm not allowed to reply to it :confused:

My questions:

1. What size torx bit is used for the door section of the quarter-panel?

2. I'm going to pop the rivets off the quarter panel, instead of removing the soft top (based on the how-to). Is it necessary to replace the rivots, and can they be installed from the "top" of the vehicle?
 
1 - 1 of 1 Posts
Top