MR2 SpyderChat banner
1 - 4 of 4 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter · #1 ·
I can't get it to turn on. It has power to it and 12 volts on the turn on lead when the radio is turned on. The power LED on the SO will flicker when the radio supplies 12 volts to the power lead.

I am connected to the SO using RCA connectors on the radio (Clarion CX501).

Am I correct in assuming that the LED will remain lit when the amp is on?

Bruce in Savannah
 

·
Registered
Joined
·
1,473 Posts
yes the RED led will stay lit if your subwoofer is on. i have the same exact one. make sure you ground it on a NON PAINT surface..
 

·
Registered
Joined
·
221 Posts
Discussion Starter · #3 ·
Thanks for the reply.

I was reasonably sure that I had a good ground as I was seeing voltage. However, just to be sure, I connected an 8 gauge ground wire from the subwoofer direct to the battery. Still no power turn on, just a flicker of the LED.

Bruce in Savannah



yes the RED led will stay lit if your subwoofer is on. i have the same exact one. make sure you ground it on a NON PAINT surface..
 
1 - 4 of 4 Posts
Top