MR2 SpyderChat banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,550 Posts
Discussion Starter #1
Over the next few weeks, we will be setting up a large compilation of torque spec values for the Spyder. I will be making this a sticky, but also LOCKING it to avoid 500 replies asking for torque specs.

I ask all of our community who know their values to start PMing me personally, and I will be adding them to the list. Also, if the organization seems a bit off at first, give it time.

Thanks!!!
 

·
Registered
Joined
·
1,550 Posts
Discussion Starter #2 (Edited)
NOTE: All values are for STOCK Toyota Parts...Aftermarket may affect the value

Body

Battery Holder 18 ft/lbs
Rear Deck Lid 15 ft/lbs
Rear Strut Tower Bar to Firewall 55 ft/lbs

Electrical


Engine

Camshaft and VVT Timing Sprocket 40 ft/lbs
Chain Tensioner Slipper 14 ft/lbs
Chain Vibration Damper 80 IN/LBS
Clutch Release Cylinder 9 ft/lbs
Crankshaft Pulley 102 ft/lbs
Cylinder Head Cover (2 Center Bolts) 80 IN/LBS
Cylinder Head Cover (Rest of Bolts) 8 ft/lbs
Drive Belt Idler 27 ft/lbs
Drive Belt Tensioner (Long Bolt) 51 ft/lbs
Drive Belt Tensioner (Short Bolts) 21 ft/lbs
Front Engine Mounting Bracket 58 ft/lbs
Front Engine Mounting Insulator (Long Bolts) 69 ft/lbs
Front Engine Mounting Insulator (Short Bolts) 40 ft/lbs
Header Bolts 27 ft/lbs
Heated Oxygen Sensor 32 ft/lbs
Intake Manifold 22 ft/lbs
Left Engine Mounting Bracket 38 ft/lbs
Left Engine Mounting Insulator (Long Bolt) 69 ft/lbs
Left Engine Mounting Insulator (Short Bolt) 38 ft/lbs
Rear Engine Mounting Insulator (Long Bolt) 69 ft/lbs
Rear Engine Mounting Insulator (Short Bolt)66 ft/lbs
Right Engine Mounting Bracket 35 ft/lbs
Right Engine Mounting Insulator 38 ft/lbs
Spark Plugs 18 ft/lbs
Starter 28 ft/lbs
Timing Chain Tensioner 80 IN/LBS

Interior


Suspension

Front

Caliper Bolts (17mm) 80 ft/lbs
Caliper Bolts (14mm) 25 ft/lbs
Crash Bolts 103 ft/lbs
Strut Top Connector Nuts (3) 29 ft/lbs
Strut Top Bolt (1) 38 ft/lbs
Swaybar (Bracket to Body) 22 ft/lbs
Swaybar Endlink to Sway Bar 32 ft/lbs
Swaybar Endlink to Control Arm 13 ft/lbs
Wheels 76 ft/lbs

Rear

Caliper Bolts (17mm) 44 ft/lbs
Caliper Bolts (12mm) 25 ft/lbs
Crash Bolts 128 ft/lbs
Drive Shaft Lock Nut 159 ft/lbs
Front Control Arm to Hub 58 ft/lbs
Front Control Arm to Body 58 ft/lbs
Lower Control Arm to Hub 76 ft/lbs
Lower Control Arm to Member Brace 64 ft/lbs
Rear Control Arm (toe) to Hub 36 ft/lbs
Rear Control Arm to Member Brace 64 ft/lbs
Rear Member Brace to Chassis 59 ft/lbs
Strut Top Connector Nuts 59 ft/lbs
Strut Top Nut 54 ft/lbs
Swaybar to Strut Link 32 ft/lbs
Swaybar Bracket to Body 29 ft/lbs
Wheels 76 ft/lbs

Transmission

Differential Fill/Drain plug 29 ft/lbs
 

·
Registered
Joined
·
872 Posts
Good reference here. One change should be made, though:

Front caliper bolts are 14 mm, not 12 mm like the rears. (Just did a brake job!)

--Doug

oops...probably should've PM'd you.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
About this Discussion
2 Replies
2 Participants
dk944s2
MR2 SpyderChat
SpyderChat Forum is a community for Toyota MR2 Spyder Enthusiasts to discuss specs, reliability and more!
Full Forum Listing
Top