MR2 SpyderChat banner

injector cleaner/tester

396 views 12 replies 7 participants last post by  dblotii  
#1 ·
I got tired of bogus info from injector people ... so I bought a cheap tester off Ebay . Pretty cool to be able to see the results and clean them yourself .

Image
Image
 
#5 ·
@phattires

That's the real deal. How time consuming is the process of cleaning and testing?
After you get the fluid loaded which takes about 15 min . then injectors about another 15 min. The test runs for a minute ....I did that about 5 times and they were tested and clean . The ultra sonic part mostly just cleaned the outside so I didn't use that after the first time I tried it out .
 
#6 ·
I got the 6 Cylinder version of that about 10 years ago.. Different Graphics, and 220V.. Got it off of Alibaba.. I've had to make a few Brackets and Bits to get things to hold and Clamp.. Bigest Hassle was making an Injector Rail that will hold Side Feed Injectors. That was a Mill and a Boring Bar for that..

I found that the Sonic Cleaner Bath does actually knock the Chunks out of inside the Injector.. Then Squirt them a Few Cycles and the Flow Pattern Comes back..

The Drain at the Bottom of Mine is Pitiful, so it takes a Few Drain Cycles to get all the Tubes Empty..

I'm glad I got it.. But its not the First Tool I use during a Troubleshooting Session.. And they are a Pain to keep.. takes up bench space..

Cap