MR2 SpyderChat banner

Partial soft top replacement?

2.4K views 13 replies 7 participants last post by  markthegrea  
#1 ·
Is it possible to replace only part of the soft top like with a Mustang? (see link below, where you can replace just the panel around the rear window)


Is that possible with the MR2 or only a full replacement of the entire thing?

Mine separated right above the window:
83903
 
#13 ·
I did my soft top myself and was a complete newbie doing it. You need a rivet kit and some special toyota glue/silicone, but I managed it. Honestly, I won't lie it was a big PITA, but it is doable. Where there is a will, there is a way. Definitely, give yourself a few days and hopefully you have a garage to do this in. If not I definitely would pay someone. In fact, I probably would still pay to have it done rather than do it again. That's just me though.
 
#14 ·
"You need a rivet kit and some special toyota glue/silicone"

I replaced mine and did NOT use either one. There is a metal strip that goes over the top in the back holding it in place. The rivets are not needed.

And it did take me 15 hours. It was a tough job but completely doable. There is a DVD with instructions.